593: BCM-0092 Yaw rate sensor. Faulty signal
Print
Diagnostic trouble code (DTC) information
Condition
Note! The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).
The yaw rate sensor, lateral accelerometer, accelerometer and angle of lean sensor (only RSC) are integrated in the active yaw control sensor for DSTC (dynamic stability and traction control). The sensors transmit information to the brake control module (BCM) indicating the size of the yaw angle, the lateral acceleration of the car, the forward acceleration and the lateral angle of lean via the Control area network (CAN).
Diagnostic trouble code (DTC) BCM-0090, BCM-0091, BCM-0092 or BCM-0093 is stored, depending on the sensor, if the control module registers a faulty signal from any of the sensors.
BCM-0090: Lateral accelerometer
BCM-0091: Accelerometer
BCM-0092: Yaw rate sensor
BCM-0093: Angle of lean sensor.
The diagnostic trouble code (DTC) can be diagnosed while the ignition is switched on.
Substitute value
Traction control is blocked
Stability control is blocked
Active yaw control is blocked
RSC system is blocked (cars equipped with RSC only).
Hint:
For information about brake system abbreviations, see Brake system, abbreviations .
Possible source
Open-circuit or short-circuit to ground in the wiring for the active yaw control sensor
Internal fault in the active yaw control sensor.
Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.
Fault symptom[s]
The anti-spin warning lamp is lit (up to and including 2002 model year)
General yellow warning lamp lit (from model year 2003)
Anti-spin does not function
The stability control system does not function
The traction control system does not function.
593: BCM-0109 Communication between control modules. Communication with the steering angle sensor. Internal fault
Print
Diagnostic trouble code (DTC) information
Condition
Note! The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).
The control module for the steering angle sensor transmits a status signal to the brake control module (BCM).
Diagnostic trouble code (DTC) BCM-0109 is stored if the brake control module (BCM) receives a message from the steering angle sensor indicating an internal fault.
Substitute value
Traction control is blocked
Stability control is blocked
Active yaw control is blocked.
Hint:
For information about abbreviations, see Brake system, abbreviations .
Possible source
Internal fault in the control module for the steering wheel angle sensor.
Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.
Fault symptom[s]
The anti-spin warning lamp is lit (up to and including 2002 model year)
General yellow warning lamp lit (from model year 2003 inclusive)
Anti-spin does not function
The stability control system does not function
The traction control system does not function.
dwa nastepne to bledy czujnikow abs
jak podrzucisz wiecej informacji o tym co ci sie wyswietla bedzie latwiej okreslic co sie dzieje. rozumiem ze nie pali ci sie kontrolka od abs?? _________________ volvo vida diagnostic-caly Londyn
http://volvodiagnostic.com
Dziękuję za te informacje. Jeśli chodzi o ABS to się nie świeci, jedyna informacja to "anty-skid". Po podpięciu do komputera są te błędy o których pisałem, wszystkie mogę wykasować oprócz jednego 040092.
rozumiem ze po przejechaniu kilku kilometrow wszystkie bledy powracaja??
jesli tak to napisz czy komunikat o anty skid sie wyswietla odrazu czy po przejechaniu kilku metrow. _________________ volvo vida diagnostic-caly Londyn
http://volvodiagnostic.com
Dołączył: 06 Mar 2011 Posty: 2 Skąd jesteś (miejscowość / region): Poznań Posiadane auto: S60
Piwa: 0/0
Wysłany: Nie 06 Mar 2011, 22:35
Temat postu:
odp
a Panowie wiedzą, że komunikat o ANTI SKID pojawia się w Volvo, gdy np. akumulator daje słabe napięcie??? ... sprawdźcie... podładujcie akumulator, a komunikat w wielu przypadkach sam zniknie
Witam. Kontrolka od trakcji wyskakiwała mi przy każdym odpalaniu samochodu i świeciła prawie caly czas czasami zgasła ale po przejechaniu kilkunastu km powracała. Pierwsze co pojechałem pod kompresor i dobiłam w każdym kole 2.6 bara (zalecane) w każdym kole i było to samo. Po oponach widziałem ze jest zbyt mało powietrza opony 205.55.16 i dopompowalem na 3bary bynajmniej na przodzie i kontrolka zgadła. Pozdrawiam.
Nie możesz pisać nowych tematów Nie możesz odpowiadać w tematach Nie możesz zmieniać swoich postów Nie możesz usuwać swoich postów Nie możesz głosować w ankietach
Popularne dyskusje w dziale: ( Volvo S60 ) Elektronika/Elektryka/Komunikaty.
Serwis internetowy, z którego korzystasz, używa plików cookies. Są to pliki instalowane
w urządzeniach końcowych osób korzystających z serwisu, w celu administrowania serwisem,
poprawy jakości świadczonych usług w tym dostosowania treści serwisu do preferencji użytkownika,
utrzymania sesji użytkownika oraz dla celów statystycznych i targetowania behawioralnego reklamy
(dostosowania treści reklamy do Twoich indywidualnych potrzeb).
To dzięki plikom cookies można logować się na forum.
Informujemy, że istnieje możliwość
określenia przez użytkownika serwisu warunków przechowywania lub uzyskiwania dostępu do informacji
zawartych w plikach cookies za pomocą ustawień przeglądarki lub konfiguracji usługi.
Szczegółowe informacje na ten temat dostępne są u producenta przeglądarki, u dostawcy usługi dostępu
do Internetu oraz w Polityce prywatności plików cookies.